Difference between revisions of "System configuration & boards addressing"
From Hydrover
m (Andrea ha spostato la pagina System configuration & boards numbering a System configuration & boards addressing senza lasciare redirect) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
* tell to the master how many boards of each type are present | * tell to the master how many boards of each type are present | ||
| − | * assing | + | * assing an address to every board |
| − | = | + | = Master configuration = |
The steps needed to configure the master of the system are: | The steps needed to configure the master of the system are: | ||
| Line 21: | Line 21: | ||
| − | = Boards | + | = Boards addressing = |
The steps needed to assign an address to a board are: | The steps needed to assign an address to a board are: | ||
| Line 27: | Line 27: | ||
* connect your PC with an USB Type-B cable to the USB port of the slave board | * connect your PC with an USB Type-B cable to the USB port of the slave board | ||
* open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code> | * open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code> | ||
| − | * configure the number of the board with '''bnum''' command e.g. <code>bnum 0</code> | + | * configure the address number of the board with '''bnum''' command e.g. <code>bnum 0</code> |
The boards address spans from 0 to 19 and are grouped by board type | The boards address spans from 0 to 19 and are grouped by board type | ||
Latest revision as of 23:28, 13 June 2017
The configuration of a system require two steps:
- tell to the master how many boards of each type are present
- assing an address to every board
Master configuration
The steps needed to configure the master of the system are:
- connect your PC with an USB to Serial adapter to the H6105-D serial port
- open PuTTY and create a serial connection with this parameters:
115200-N-8-1 - configure the number of H6105-E boards with ce num command e.g.
ce num 1 - configure the number of H6103 boards with io num command e.g.
io num 1 - configure the number of H6104-P boards with ca num command e.g.
ca num 1 - save the configuration with the save command
The number of boards spans from 0 to 20 and are grouped by board type
Boards addressing
The steps needed to assign an address to a board are:
- connect your PC with an USB Type-B cable to the USB port of the slave board
- open PuTTY and create a serial connection with this parameters:
115200-N-8-1 - configure the address number of the board with bnum command e.g.
bnum 0
The boards address spans from 0 to 19 and are grouped by board type
