Difference between revisions of "System configuration & boards addressing"

From Hydrover
Jump to: navigation, search
m (Andrea ha spostato la pagina System configuration & boards numbering a System configuration & boards addressing senza lasciare redirect)
 
(2 intermediate revisions by the same user not shown)
Line 2: Line 2:
  
 
* tell to the master how many boards of each type are present
 
* tell to the master how many boards of each type are present
* assing a number to every board
+
* assing an address to every board
  
  
Line 21: Line 21:
  
  
= Boards numbering =
+
= Boards addressing =
  
 
The steps needed to assign an address to a board are:
 
The steps needed to assign an address to a board are:
Line 27: Line 27:
 
* connect your PC with an USB Type-B cable to the USB port of the slave board
 
* connect your PC with an USB Type-B cable to the USB port of the slave board
 
* open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code>
 
* open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code>
* configure the number of the board with '''bnum''' command e.g. <code>bnum 0</code>
+
* configure the address number of the board with '''bnum''' command e.g. <code>bnum 0</code>
  
 
The boards address spans from 0 to 19 and are grouped by board type
 
The boards address spans from 0 to 19 and are grouped by board type

Latest revision as of 23:28, 13 June 2017

The configuration of a system require two steps:

  • tell to the master how many boards of each type are present
  • assing an address to every board


Master configuration

The steps needed to configure the master of the system are:

  • connect your PC with an USB to Serial adapter to the H6105-D serial port
  • open PuTTY and create a serial connection with this parameters: 115200-N-8-1
  • configure the number of H6105-E boards with ce num command e.g. ce num 1
  • configure the number of H6103 boards with io num command e.g. io num 1
  • configure the number of H6104-P boards with ca num command e.g. ca num 1
  • save the configuration with the save command

The number of boards spans from 0 to 20 and are grouped by board type


Boards addressing

The steps needed to assign an address to a board are:

  • connect your PC with an USB Type-B cable to the USB port of the slave board
  • open PuTTY and create a serial connection with this parameters: 115200-N-8-1
  • configure the address number of the board with bnum command e.g. bnum 0

The boards address spans from 0 to 19 and are grouped by board type