Revision as of 15:31, 15 June 2017

this section explain how to connect and dowanload a PAWN program to the H6105-D master

Hardware connection

we need to make two connections:

on the serial port we will find the Console with the command promt cp> pressing the ENTER key will show a help message

the USB port has tree operating modes:

libusb, this mode is active when the script is running and can be used to give the control of the system to a PC program
disk mode 1, this mode is active when the script is not running and can be used to flash a new PAWN program
disk mode 2, this mode is active during the firmware update and can be usd to flash a new firmware

follow this steps to download a new program into the board:

enter in disk mode 1 with the script stop command
at this point you should see a new usb disk unit connected to your PC named HYDCPAMXDRV inside this disk there is only one file named PRMGFILE.AMX
delete this file then copy the new one
start your new program with script run or reset the board with reset

@@ Line 33: / Line 33: @@
 = Programming =
-enter in disk mode 1 with the <code>script stop</code> command
+follow this steps to download a new program into the board:
-at this point you should see a new usb disk unit connected to your PC named <code>HYDCPAMXDRV</code>
+* enter in disk mode 1 with the <code>script stop</code> command
+* at this point you should see a new usb disk unit connected to your PC named <code>HYDCPAMXDRV</code> inside this disk there is only one file named <code>PRMGFILE.AMX</code>
-inside this disk there is only one file named <code>PRMGFILE.AMX</code>
+* delete this file then copy the new one
+* start your new program with <code>script run</code> or reset the board with <code>reset</code>
-first delete this file then copy the new one
-when the copy is done you can:
-* start your new program with <code>script run</code>
-* reset the board with <code>reset</code>