Difference between revisions of "Programming H6105-D"

From Hydrover
Jump to: navigation, search
(Programming)
(USB port)
Line 27: Line 27:
 
* '''libusb''', this mode is active when the script is running and can be used to give the control of the system to a PC program
 
* '''libusb''', this mode is active when the script is running and can be used to give the control of the system to a PC program
 
* '''disk mode 1''', this mode is active when the script is not running and can be used to flash a new PAWN program
 
* '''disk mode 1''', this mode is active when the script is not running and can be used to flash a new PAWN program
* '''disk mode 2''', this mode is active during the firmware update and can be usd to flash a new firmware
+
* '''disk mode 2''', this mode is active during the firmware update and can be used to flash a new firmware
 
 
 
 
  
 
= Programming =
 
= Programming =

Revision as of 00:36, 16 June 2017

this section explain how to connect and dowanload a PAWN program to the H6105-D master


Hardware connection

we need to make two connections:

  • use the USB to Serial adapter to connect to the serial port
  • use the USB Type-B cable to connect to the USB port

Functions of the ports

Serial Port

on the serial port we will find the Console with the command promt cp> pressing the ENTER key will show a help message

Cp-console.png

USB port

the USB port has tree operating modes:

  • libusb, this mode is active when the script is running and can be used to give the control of the system to a PC program
  • disk mode 1, this mode is active when the script is not running and can be used to flash a new PAWN program
  • disk mode 2, this mode is active during the firmware update and can be used to flash a new firmware

Programming

follow this steps to download a new program into the board:

  • enter in disk mode 1 with the script stop command
  • at this point you should see a new usb disk unit connected to your PC named HYDCPAMXDRV inside this disk there is only one file named PRMGFILE.AMX
  • delete this file then copy the new one
  • start your new program with script run or reset the board with reset