356
edits
Changes
no edit summary
The configuration of a system require two steps:
* tell to the master how many boards of each type are present
* assing a number to every board
= System configuration =
The steps needed to configure the master of the system are:
* connect your PC with an USB to Serial adapter to the [[H6105-D]] serial port
* open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code>
* configure the number of [[H6105-E]] boards with '''ce num''' command e.g. <code>ce num 1</code>
* configure the number of [[H6103]] boards with '''io num''' command e.g. <code>io num 1</code>
* configure the number of [[H6104-P]] boards with '''ca num''' command e.g. <code>ca num 1</code>
* save the configuration with the '''save''' command
The number of boards spans from 0 to 20 and are grouped by board type
= Boards numbering =
The steps needed to assign an address to a board are:
* connect your PC with an USB Type-B cable to the USB port of the slave board
* open PuTTY and create a serial connection with this parameters: <code>115200-N-8-1</code>
* configure the number of the board with '''bnum''' command e.g. <code>bnum 0</code>
The boards address spans from 0 to 19 and are grouped by board type
