356
edits
Changes
Creata pagina con "this section explain how to connect and dowanload a PAWN program to the H6105-D master = Hawrdware connection = we need to make two connections: * use the USB to Seri..."
this section explain how to connect and dowanload a PAWN program to the [[H6105-D]] master
= Hawrdware connection =
we need to make two connections:
* use the USB to Serial adapter to connect to the serial port
* use the USB Type-B cable to connect to the USB port
= Functions of the ports =
== Serial Port ==
on the serial port we will find the Console with the command promt <code>cp></code>
pressing the ENTER key will show a help message
== USB port ==
the USB port has tree operating modes:
* '''libusb''', this mode is active when the script is running and can be used to give the control of the system to a PC program
* '''disk mode 1''', this mode is active when the script is not running and can be used to flash a new PAWN program
* '''disk mode 2''', this mode is active during the firmware update and can be usd to flash a new firmware
= Entering disk mode 1 =
to enter in disk mode 1 you must stop a running script with the <code>script stop</code> command
at this point you should see a new usb disk unit connected to your PC named <code>HYDCPAMXDRV</code>
inside this disk there is only one file named <code>PRMGFILE.AMX</code>
first delete this file then copy the new one
when the copy is done you can:
* start your new program with <code>script run</code>
* reset the board with <code>reset</code>
= Hawrdware connection =
we need to make two connections:
* use the USB to Serial adapter to connect to the serial port
* use the USB Type-B cable to connect to the USB port
= Functions of the ports =
== Serial Port ==
on the serial port we will find the Console with the command promt <code>cp></code>
pressing the ENTER key will show a help message
== USB port ==
the USB port has tree operating modes:
* '''libusb''', this mode is active when the script is running and can be used to give the control of the system to a PC program
* '''disk mode 1''', this mode is active when the script is not running and can be used to flash a new PAWN program
* '''disk mode 2''', this mode is active during the firmware update and can be usd to flash a new firmware
= Entering disk mode 1 =
to enter in disk mode 1 you must stop a running script with the <code>script stop</code> command
at this point you should see a new usb disk unit connected to your PC named <code>HYDCPAMXDRV</code>
inside this disk there is only one file named <code>PRMGFILE.AMX</code>
first delete this file then copy the new one
when the copy is done you can:
* start your new program with <code>script run</code>
* reset the board with <code>reset</code>
